Air Midi Micros AirMigi Plane The AirMigi is a slow flying micro plane made of balsa wood and tissue.  This plane has a 12 inch wingspan with a wing area of 36 square inches.  This AirMigi design has proven to be very durable with over a year of flying and no major damage.  LiPo cells from 85 to 200 mAh can be used with this plane.  The longest flight time was a little over 55 minutes outdoors using a Fullriver 200 mAh cell.  Plans, instructions, photos, and a video are below.  AirMigi kits with printed plans, instructions, laser cut wing ribs, brass wire, and heat shrink tubing are available for $8 each. The electronic gear used on the AirMigi pictured below was made by MicroInvent, and Gasparin.  A MicroInvent MINOR receiver, two MCA2 actuators, and a Gasparin 4.5:1 ratio gearbox/motor with a 4" carbon fiber prop.  A Gasparin GB26S7O 2.6:1 gearbox/motor could also be used.  Micro wheels and control horns are available on the Misc page.  Other gear can be used with the AirMigi like a Micro9 3 channel RX, and MiniAct actuators from Plantraco.  A Plantraco 7mm direct drive motor with a Tri-turbofan prop was used on the prototype of this plane. Build it, fly your creation, and have fun.   Plane Kit $8.00 In Stock Quantity:   Plane Description:   Model Flight Weight: 15 to 17 grams   Wingspan: 12"   Wing Area: 36 sq. in.   Controlled Elements: Rudder, Elevator, Motor       Plane Kit Items:   Includes: Printed plans, instructions, diagrams   Wing Ribs: Sheet of 28 ribs, 1/16" thickness. Need 11 ribs for plane.   Heat Shrink Tubing: 3/64" Dia Black (3" piece)   Brass Wire: .016" Dia (4" piece)     Purchase balsa wood for AirMigi on the Building Supplies page.   Plans AirMigi Plans (pdf file)   Instructions AirMigi Building Instructions AirMigi Component Placement AirMigi Tissue Covering   AirMigi Video AirMigi Video (22.2 MB)   AirMigi Photos   page updated: 10/01/09 Back to Top Copyright © 2008 Air Midi Micros. All rights reserved.